VICTRON 100A BUCK BOOST
DC-DC CHARGER FOR CHARGING A 12V OR 24V SERVICE BATTERY IN VEHICLES WITH A SMART ALTERNATOR
Reference No. ORI303100000
DC-DC Converter for charging a 12V or 24V service battery in vehicles with a smart alternator (regenerative braking, Euro 5 and Euro 6 engines)
The Buck-Boost DC-DC Converter is a DC-DC charger for charging a 12V or 24V service battery in vehicles with a smart alternator. The converter will charge the auxiliary battery with a pre-set charge voltage, eliminating high voltages (e.g. Mercedes: 15,4V) and low voltages.
‘Engine running’ detection system
Deep discharge of the vehicle's starting battery is avoided by a built-in ‘engine running’ detection system. Instead of this detection system, the converter can also be activated by means of a programmable input (D+, CAN bus or (+)15 connection).
The converter can be fully programmed by means of a simple and user-friendly PC application. (USB type A male to USB type B male cable needed)
One product for 12V, 24V and 12/24V systems
The converter can be programmed to charge a 12V or a 24V auxiliary battery from either a 12V or a 24V alternator and starter battery.
Charge current and input current limiter
The output current is determined by the following factors:
-The maximum charge current setting.
-The maximum input current setting.
-The maximum operating temperature limit of the converter.
Input status indication (LED) Green: converter on.
Yellow: input voltage below threshold, converter off. Red: over temperature, converter off.
Blue, quick flash: engine running, converter will start after preset delay.
Blue, slow flash: the converter is OFF and activation is blocked due to low input voltage.
Output status indication (LED)
Green: converter off, battery voltage normal. Yellow: converter off, battery voltage low.
Red: converter off, battery discharged or not connected. Purple: converter on.
Buck-Boost DC-DC Converter
Input voltage range
Under voltage threshold
Output voltage range
Maximum charge current
Converter off, LEDs off (power save
On/off input (pin 1, purple wire)
‘On’ threshold voltage
Maximum input voltage
Output pin 1 and pin 2
Output voltage if activated
Vpinout = Vin
Maximum current (per pin)
Ipinout = 1A
Operating temperature range
Max current: up to 60°C
165 x 120 x 30mm
213 x 120 x 30mm
288 x 162 x 95mm